Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: pharoah007 on October 10, 2012, 06:34:43 am

Title: Pre cut (CNC) bartop kits
Post by: pharoah007 on October 10, 2012, 06:34:43 am

Good day all :)

I have been reading a lot of posts while away form home on business and I notices something....

A lot of posts have CNC cut bartop cabinets.  The creators of these cabinets are asked if they would consider making and selling kits to members, shipped in a flat box.  Some creators live too far away to make shipping possible, but were more than happy to share the CNC files.

My question is....

Have any of these "kits" ever become available to members?  If so, where do I start looking?

Title: Re: Pre cut (CNC) bartop kits
Post by: cigardude on October 10, 2012, 08:31:12 am

If they have not, you can always go on eBay to get a kit. You can also google it and some companies sell the flat pack for you to build. I think a few people on this forum went that route.

Title: Re: Pre cut (CNC) bartop kits
Post by: Unstupid on October 10, 2012, 12:23:35 pm

Quote from: pharoah007 on October 10, 2012, 06:34:43 am

A lot of posts have CNC cut bartop cabinets.  The creators of these cabinets are asked if they would consider making and selling kits to members, shipped in a flat box.  Some creators live too far away to make shipping possible, but were more than happy to share the CNC files.

The nerve of them!   ;D

Here check out this place for flat packed kits! http://www.mameroom.com/Products_kits.asp (http://www.mameroom.com/Products_kits.asp)