Build Your Own Arcade Controls Forum

Main => Monitor/Video Forum => Topic started by: hooddoctor on September 20, 2012, 03:10:24 am

Title: Makvision 25" trisync horizontal problem
Post by: hooddoctor on September 20, 2012, 03:10:24 am

I've got one of the new makvision 25" trisyncs with the 3129 chassis. The problem is when in CGA mode, I get all resolutions shift far left and I've adjusted the hwidth, hposition and even the hold all the way and I still have about a half inch on the right. Is anyone familiar with these chassis that could point me to another adjustment on the board? I thought I could maybe adjust the horizontal width coil but there does not seem to be one. I just need it to shift about a half inch. Thanks.

Title: Re: Makvision 25" trisync horizontal problem
Post by: Gray_Area on September 25, 2012, 03:26:52 pm

Where'd you get it?

Title: Re: Makvision 25" trisync horizontal problem
Post by: hooddoctor on September 25, 2012, 05:41:50 pm

I got it from a Arcade supply in Atlanta which is 100 miles from me. Would cost me alot of money to ship it back. Was hoping I could adjust it without being the picture is great just the far left shift in CGA mode. Vga is fine though.