Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: Japedo on June 13, 2012, 09:13:31 pm
-
If this has been gone over before I apologize, I searched and did not find anything.
I recently purchased Tekken 3 in a showcase cab. I'm about to purchase a Street Fighter PCB and need to wire in the extra two buttons. I think the cab might be prewired for the extra buttons. I think it might be prewired because the control panel already has precut holes where the buttons would go, and there is a harness for players 3 and 4. Also in test mode on the button function test, the buttons are "shadowed." I was hoping someone has a wiring diagram for this cab, I believe they are built as generic cabs then they just throw in the PCB.... I could be wrong though, I don't know much about these, but before I purchase and install the kick harness, it looks like the cab is already prewired for it.
Thanks for the help in advance.