Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: mcseforsale on May 23, 2012, 10:10:34 pm

Title: Show me your vandal-switches!
Post by: mcseforsale on May 23, 2012, 10:10:34 pm

Just got my vandal switch and I'm looking for ideas on where to mount it.  I was going to mount it in the bezel, through the plexi that's going there, but I don't think it will be a fun install.

So, I'm looking for ideas on where to put it.  Or, if you have pushbutton power switches, I'd like to see where you have those, too.

AJ

Title: Re: Show me your vandal-switches!
Post by: Rok on May 26, 2012, 11:44:31 pm

My power switch is on the back panel/access door.

Title: Re: Show me your vandal-switches!
Post by: CoryBee on May 27, 2012, 12:06:30 am

Here is the back panel for one of my bartops. Momentary Pushbutton for On\Off, DC Jack for power, Light up LED rocker switch for Main Power cut off, and USB port for Male-Male usb cord to use the Bartop as a PC Controller.

(http://i81.photobucket.com/albums/j227/corydrippon/Bartop%20Arcade%20Mark%202%20-%20Build%20logs/GEDC0787.jpg)

(http://i81.photobucket.com/albums/j227/corydrippon/Bartop%20Arcade%20Mark%202%20-%20Build%20logs/GEDC0796.jpg)