Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: gstav on March 24, 2012, 11:53:25 am

Title: install a 4-pin annode RGB to a button??
Post by: gstav on March 24, 2012, 11:53:25 am

Hi!

I have the Seimitsu PS-14-KN and bout some annode 4 pins RGB leds to light them up!
I've seen guides of installing pre-made RGB boards sutch as UILA and ARCEYE, but is there any instructions made
for my type of install?

Any smart way of doing this? Guess I have to drill a hole in the base somewere..  ::)

Cheers! :cheers:

Title: Re: install a 4-pin annode RGB to a button??
Post by: BobA on March 24, 2012, 04:08:59 pm

You can bend the pins of your LED out so you can install it the same way as the UILA board.   Holes will have to be in the same place and you would have to solder wires to all the pins (4).

Title: Re: install a 4-pin annode RGB to a button??
Post by: gstav on March 25, 2012, 08:47:49 am

Thanks mate!  ;D
Found a gudie installing the UIila board (http://"http://www.youtube.com/watch?v=HmUiFtZGQ30")

Do you think is enough with one RGB led or do i need 2 / button?

This is the type of RGB's that I have
http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a]http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a]http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a (http://www.ebay.com/itm/20-pcs-5mm-4PIN-Common-Anode-RED-GREEN-BLUE-RGB-LED-R-/190565595706?pt=LH_DefaultDomain_0&hash=item2c5e983a3a)


Thanks for the help!  :applaud:

Title: Re: install a 4-pin annode RGB to a button??
Post by: BobA on March 25, 2012, 09:34:26 am

No real way to tell until you get your LEDs and try them.  :dunno

Title: Re: install a 4-pin annode RGB to a button??
Post by: gstav on March 25, 2012, 11:13:29 am

*lol* true! :burgerking: