Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Lilwolf on September 21, 2003, 12:07:52 pm

Title: Octopus -> Jamma... Anyone ever do it?
Post by: Lilwolf on September 21, 2003, 12:07:52 pm

I have a vga octopus cable (splits the rgb and sync).

Has anyone ever used one to connect to a jamma and have the pinouts?

I was hoping not to have to figure out if there is any weird connections inside the cable...

Thanks

Title: Re:Octopus -> Jamma... Anyone ever do it?
Post by: TheGatesofBill on September 21, 2003, 12:11:27 pm

This may be helpful: http://www.solvalou.com/arcade_jamma.php . Scroll down and it shows you where everything goes on the harness.

Off topic, but are you a fur, or do you just like wolves?

Title: Re:Octopus -> Jamma... Anyone ever do it?
Post by: Lilwolf on September 22, 2003, 02:02:48 pm

Yeah... I already had that... but I finally just got the ohm meter out and 10seconds later verified all the connections.

And for my sig?  Goto the Everything Else board... I think it's on the 4th page of 'what does your sig mean" topic

Title: Re:Octopus -> Jamma... Anyone ever do it?
Post by: TheGatesofBill on September 22, 2003, 03:25:41 pm

I can't find that topic.

Title: Re:Octopus -> Jamma... Anyone ever do it?
Post by: Lilwolf on September 22, 2003, 03:51:08 pm

"Where did your alias come from?"  about 1/2 way down... (reason I'm not just repeating it is... some of them are really funny..."

sad thing... I've been posting for years here... and I don't know how to link a single thread (without searching)