Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: gatordad on January 10, 2012, 11:09:15 pm

Title: AVGA 3000 Driver install done, DVi Port no image, is that normal after Tri sync?
Post by: gatordad on January 10, 2012, 11:09:15 pm

Hi guys
I'm configuring a new computer and I just installed XP with all the latest updates on a new drive, Troubleshoot a bad stick of RAM that was causing the Blue screen of Death, now I'm on to the AVGA 3000 install.

I removed all my orig ati drivers, installed the avga 3000, installed the drivers, set up the tri sync utility, and choose MultiFrequency Monitor 15-38 as this will be used with a wg d 9800.

I still have this running off a lcd and now I have no image from the DVI port, Is that normal after running the tri sync utility?

I want to install the rest of the misc stuff (software, pc games etc.) before putting this in the cab and hooking up the wg d9800

Any advice is appreciated

Title: Re: AVGA 3000 Driver install done, DVi Port no image, is that normal after Tri sync?
Post by: gatordad on January 11, 2012, 10:31:57 am

Just to add some additional info
Before I installed the Tri sync utility, I had dvi port lcd image and was able to verify that all the drivers loaded or at least I was able to see the different resolutions that were now available.

Only after running the Tri Sync utility did the DVI port lcd stop responding

Do you think I need to set up mirrored displays or extended desktop?
I am going to uninstall and try again tonight but It seems more difficult than it should be.

Title: Re: AVGA 3000 Driver install done, DVi Port no image, is that normal after Tri sync?
Post by: AndyWarne on January 12, 2012, 05:19:31 am

The multi-frequency monitor should be connected to the VGA port not the DVI port.

Andy