Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: caskad on August 30, 2011, 02:29:52 am

Title: X-arcade problem
Post by: caskad on August 30, 2011, 02:29:52 am

Hello,


i don't know if i'm rgight section but, will ask for help :)


I try to connect (Mars ME111 13 pins, coin door), on buton 7, and i make a "boulette"...

http://www.xgaming.com/support/questions/54/Advanced+BYO+Kit+installation+diagram+with+wiring+schematic. (http://www.xgaming.com/support/questions/54/Advanced+BYO+Kit+installation+diagram+with+wiring+schematic.)

controller j6 is out.... buttons 3.6.7.8 doesn't respond att all .. :banghead:


it m' not very good, so i test the 4 diode (led in english??) and there are OK with the multimeters (gives me 0.6 , i can't remember  yet..)

Is there a shema or someone who can guide me to correct test this?

cheers

Title: Re: X-arcade problem
Post by: BobA on August 30, 2011, 04:57:55 pm

Your Mars ME111 is powered by 12V.  Your X arcade is 5V.  Depending on what you connected to the X arcade controller you may have blown the inputs on j6.   You did not provide into on what you connected so I am only guessing at this point.

Title: Re: X-arcade problem
Post by: gryhnd on August 31, 2011, 03:05:58 pm

I just wired my coin door triggers to the buttons on my X-Arcade tank stick that simulate a coin drop.  So when you put in a coin, the circuit completes and it's the same as the button being pressed. Requires no power at all from the door.

After that I did also wire a hidden switch that breaks the button circuit so I can force use of the coin door only.

Very simple wiring.

Title: Re: X-arcade problem
Post by: caskad on September 01, 2011, 07:10:21 pm

Thx for explain,

I've wiring on the fly and make a stupid mistake  :badmood:

controller j6 is out  :banghead:

rebuy one !  :censored: