Build Your Own Arcade Controls Forum

Main => Software Forum => Topic started by: UncleMame on May 22, 2011, 03:27:35 pm

Title: Fusion esacpe issue
Post by: UncleMame on May 22, 2011, 03:27:35 pm

I looked and didn't find any thread(I hope I didn't miss it).  Does anyone know if a CP button can be mapped to Fusion for the escape key ?  I haven't found that as an option in the config.  It maps the general control buttons, but not an escape (or save/restore state for that matter either).  Anyone know if this can be done ?

Thanks

Title: Re: Fusion esacpe issue
Post by: gonzo90017 on May 23, 2011, 03:07:58 pm

Not that I know of. You need to use Closemul.

Title: Re: Fusion esacpe issue
Post by: UncleMame on May 23, 2011, 06:49:37 pm

Thanks,  I'll try it.

I never would have even known about Closemul(never saw this before) - I appreciate the tip!

Title: Re: Fusion esacpe issue
Post by: zorrobandito on May 24, 2011, 07:10:58 am

Closemul will work but Fusion will quit with escape when it is run fullscreen:

fusion.exe "[rompath]\[name].[romext]" -gen -fullscreen

Title: Re: Fusion esacpe issue
Post by: UncleMame on May 24, 2011, 09:06:19 pm

Although the full screen helps to use the esc key(I already can do this) - What I was really looking for was a solution to allow a joystick button to do this - I'm going to investigate closemul

Thanks