Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: ZERO on February 10, 2011, 07:43:02 pm

Title: Spinner/joystick question
Post by: ZERO on February 10, 2011, 07:43:02 pm

I may have ordered the wrong spiner, but I'm not sure. I ordered a quad controller from north coast custom I then ordered my spiner from Ultimate arcade, it was there only one so I was thinning they where all the same. But when I tried to install it the pin does not come all the way up. Do I need to drill it?  Did I buy the wrong spiner? If you need more info let me know.



And about joysticks  I have 4 old joysticks from an arcade, I could use them but I would have to drill the 4 bolts out. Or is there joysticks that don't require me to dill?

Title: Re: Spinner/joystick question
Post by: BobA on February 10, 2011, 08:13:31 pm

Don't know which spinner you ordered as the site for ultimate arcade did not come up.   This is the spinner that is referenced by NC Custom.

Tornado (http://www.happcontrols.com/amusement/gameparts/95265700.htm)

Title: Re: Spinner/joystick question
Post by: ZERO on February 11, 2011, 03:18:36 am

http://www.ultimarc.com/JShopServer/section.php?xSec=10 (http://www.ultimarc.com/JShopServer/section.php?xSec=10)


looks like i got the wrong one thanks