Build Your Own Arcade Controls Forum
Main => Audio/Jukebox/MP3 Forum => Topic started by: roberts123 on December 14, 2010, 10:17:08 pm
-
So to do another upgrade on my 1977 Rowe AMI jukebox (and mostly more to my liking.) I was wondering if there was a way to make new display pieces to my jukebox. I would like to re-make all of the display pieces with different wording and different font but I'm not to sure about how to go about it (and not even sure if it can be done. This are the four pieces i would like to re-make. If anybody would know how to go about this process please inform me thank you.
-
Since I had the time I decided that maybe I could start work on remaking one of the them. I believe that this one will replace the stereo selections piece.
-
I had some time today to work on another piece this one i think will replace the ROWE AMI piece. Tell me what you think.
-
The last piece I made i felt like i had underplayed it and just wanted to get it done. But I think if it is worth doing I might as well do it right so i decide to go back and do a little editing to the new piece,
-
I like it!
-
I decided to switch the first picture I made and this one. The new one will be in the 200 Selections spot and the first one I made will be in the place of the solid state piece. I think it will look better and make a better fit to. Tell me what you think thank you.
-
I still have to clean the glass and I still would like to print it on picture paper but here is the mock up. I think it is looking pretty good.
-
Quick question on making my next piece. So I am about to make my last piece but I ran into a problem. The piece I want to make next are the one that show says make "Make Standard Selection" and "Make any Selection." The problem I am running into is that a light shines through those pieces and I don't know how to make it very visible when the light shines through. :dunno Any help with making this work is greatly appreciated. Also I and going to print it on photo paper to make it look good and I'm sure that could cause a problem with the visibility of the light coming through it. Thank you.
-
Well I have been able to get all of them done printed and cut of to fit the spots. I think they are looking really good (at least to my liking). Tell me what you think so far.
MOV01464 (http://www.youtube.com/watch?v=iywqzWaQzCc#)