Build Your Own Arcade Controls Forum

Main => Main Forum => Topic started by: Creeper on November 27, 2010, 04:06:14 pm

Title: Happ Perfect 360 Install
Post by: Creeper on November 27, 2010, 04:06:14 pm

Can anyone tell me the correct way to install a Happ Perfect 360? I don't fully understand where to get the power from for the +5V. I'm sure it's something obvious but I need pointed in the right direction.  :dunno

Title: Re: Happ Perfect 360 Install
Post by: Franco B on November 27, 2010, 04:23:54 pm

If you have a Jamma cab then I would imagine you take it from the Jamma PSU. If you have them installed in a MAME cab then you will most likely take power from a spare PC molex (red and black wires).

Title: Re: Happ Perfect 360 Install
Post by: Creeper on November 27, 2010, 04:33:24 pm

Ok, so just strip the black and red wires from an extra molex, sounds like a plan. Thank you sir.

Title: Re: Happ Perfect 360 Install
Post by: Thenasty on November 28, 2010, 10:42:56 am

I tap mine on the IPAC.

Title: Re: Happ Perfect 360 Install
Post by: nick3092 on November 28, 2010, 03:43:50 pm

My CP is modular, so I just cut one end off a USB cable and pulled +5 and GND off of that.

Title: Re: Happ Perfect 360 Install
Post by: Creeper on November 28, 2010, 05:50:15 pm

I jacked some power from a molex, working great. Thanks guys!

But I have a new question: The Perfect 360's are working pretty awesome but I'm not sure how to get them working 8 way, currently just up/down/left/right.

Any help?

Note: I'm using MAME if that helps.


EDIT: I am retarded, I had the actuators upside down. Nevermind!

Title: Re: Happ Perfect 360 Install
Post by: Gray_Area on December 01, 2010, 05:05:44 pm

Quote from: Creeper on November 28, 2010, 05:50:15 pm

EDIT: ...I had the actuators upside down. Nevermind!

Yeah.

IMPORTANT:
8-Way:Install small diameter
towards E-Ring
4-Way:Install large diameter
towards E-Ring

http://happcontrols.com/images/pdf/ins-0057.pdf (http://happcontrols.com/images/pdf/ins-0057.pdf)