Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: crzywolf on October 03, 2010, 07:40:18 pm

Title: SOLD
Post by: crzywolf on October 03, 2010, 07:40:18 pm

   I'm just looking to sell this stuff . I'm not looking to trade  (well maybe for a USB cable for an I pac). Just make an offer .



 This is a dual jamma adapter . I bought this off Ebay but , never used or tested it . This adapter DOES NOT HAVE THE WIRES FOR THE JOYSTICKS OR BUTTONS . I was told by the seller you could add the wires to the harness .

(http://i243.photobucket.com/albums/ff189/crzywolf_photos/th_IMAG0024-1.jpg) (http://s243.photobucket.com/albums/ff189/crzywolf_photos/?action=view&current=IMAG0024-1.jpg)

 "Arcade supergun motherboard MK II" It worked fine on my singal slot NeoGeo motherboard . I have not tried it on any other pcb's .

(http://i243.photobucket.com/albums/ff189/crzywolf_photos/th_IMAG0026-1-1.jpg) (http://s243.photobucket.com/albums/ff189/crzywolf_photos/?action=view&current=IMAG0026-1-1.jpg)

 Jamma edge pcb (with extra connectors on top) to a 62 pin dsub connector .

(http://i243.photobucket.com/albums/ff189/crzywolf_photos/th_IMAG0025-1.jpg) (http://s243.photobucket.com/albums/ff189/crzywolf_photos/?action=view&current=IMAG0025-1.jpg)

Working Aim-Trak in a guncon case .

(http://i243.photobucket.com/albums/ff189/crzywolf_photos/th_IMAG0028.jpg) (http://s243.photobucket.com/albums/ff189/crzywolf_photos/?action=view&current=IMAG0028.jpg)

untested playstation 2 to Jamma adapter .   Sold

(http://i243.photobucket.com/albums/ff189/crzywolf_photos/th_IMAG0027.jpg) (http://s243.photobucket.com/albums/ff189/crzywolf_photos/?action=view&current=IMAG0027.jpg)