Build Your Own Arcade Controls Forum

Main => Buy/Sell/Trade - non-retail => Topic started by: RayB on October 02, 2010, 03:32:18 pm

Title: WTB: e-clip for Midway joystick (FOUND)
Post by: RayB on October 02, 2010, 03:32:18 pm

I need an e-clip for a Ms Pac Man joystick. The shaft is way smaller than your typical Wico. Manual says "1/4".

Thanks

Got some. thanks.

Title: Re: WTB: e-clip for Midway joystick
Post by: Franco B on October 02, 2010, 04:22:55 pm

If you can measure or find out the groove size I can send you one FOC.

Title: Re: WTB: e-clip for Midway joystick
Post by: Encryptor on October 02, 2010, 08:34:48 pm

I can do the same. I have a whole kid of them I bought at Harbor Freight.

Encryptor

Title: Re: WTB: e-clip for Midway joystick
Post by: RayB on October 03, 2010, 12:17:29 pm

Thanks!

It's hard to measure this thing.

The shaft diameter is 1/4" or possibly as much as 9/32" if you want to be ultra precise.

The groove seems to be maybe 7/32"

The manual calls it 1/4 e-ring, so I'm assuming these things are measured based on the shaft, not the groove, and the ring is measured based on the inner diameter, not including the little bumps

Title: Re: WTB: e-clip for Midway joystick
Post by: Encryptor on October 03, 2010, 05:19:42 pm

RayB

I believe I have a pacman stick in the basement. I'll check it and get the one that fits. PM me or email me your address and I'll send it to you.

Encryptor