Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: eclipso on September 24, 2010, 09:53:05 pm
-
I got my polo 25 back from getting a issue resolved and in the meantime I had put in a temp monitor, needless to say as I am putting the polo back in and when going to hook up the vid I cannot for the life of me get the wires to bite into the j106 connector and want to know if there is a trick to getting them in there, its something so silly and its giving me fits :-[
-
Alright, I took a few and got an even smaller screwdriver and just worked the wires down in there, however now I plugged her in and she looks great with the exception that the picture is upside down and I am not 100% sure why. Any suggestions?
I have the j106 from right to left looking at it: red, green, blue, black, nothing, white.
I think I might have the white (currently in the horiz sync or comp sync) in the wrong pin, but I really am not sure.
-
Find the vertical yoke wires and reverse (switch) them. These will be the (usually) yellow and green wires running from the main chassis board to the yoke on the CRT neck. This will flip the picture upside-down. So, yook green up to where yellow was and yellow up to where green was. Don't mess with the blue and red wires if they're on the same connector. Leave them in the same place.
-
Thank you that was it.