Build Your Own Arcade Controls Forum
Main => Main Forum => Topic started by: ragnar on September 16, 2010, 11:39:13 pm
-
So, my cab (see sig) is pretty much up and running. now I am trying to get the ipac2 set up. Everything is going great except that I can not assign the shift function.
What I am doing:
1) Launch winIpac
2) set to table view
3) click on P1/2 shift cell
4) Upon prompting, press button that I want to have shift assigned to
5) nothing gets assigned.
What am I doing wrong here?
-
Owe, my head.
SOLVED!
OK, I have to click the "shift cell" then click on the cell that represent the iPac input within the GUI with the mouse that I want to act as the shift key. I don't want to press the actual pushbutton.
After re-reading the message from winIpac, I understand its meaning.
-
I was going to reply because I had the same issue. After staring at the screen for an hour I actually read the status which told you to click with the mouse the button you wanted to use for the shift function. I want that hour of my life back.
-
I was going to reply because I had the same issue. After staring at the screen for an hour I actually read the status which told you to click with the mouse the button you wanted to use for the shift function. I want that hour of my life back.
Only half an hour of my life. I got lucky. Actually, the solution was in another thread here at byoac. I did a seearch for "ipac shift" that worked out. But i owuld have to say that hte GUI is somewhat non intuitive in regards to setting the shift key.