Build Your Own Arcade Controls Forum
Main => Project Announcements => Topic started by: dfg on August 26, 2010, 10:59:34 am
-
Ok so my Megalo 410 has finally arrived.Still waiting on for my jpac and arcadevga card, should be in next week.
Opened up the centre control panel and had a bit of a look inside,(does this thing look confusing as hell lol!) sorry if it is a bit of a silly question but i noticed 2 vga connections onto this board. Which one of the 2 would i need to plug into my Jpac once it arrives?
http://img840.imageshack.us/i/pic1rc.jpg/ (http://img840.imageshack.us/i/pic1rc.jpg/) the megalo
http://img833.imageshack.us/i/vgah.jpg/ (http://img833.imageshack.us/i/vgah.jpg/) side view
http://img838.imageshack.us/i/vga2.jpg/ (http://img838.imageshack.us/i/vga2.jpg/) other side view
http://img830.imageshack.us/i/vga3.jpg/ (http://img830.imageshack.us/i/vga3.jpg/) close up
i can take more pics if it helps.
-
The Megalo 410 is capable of 31Khz for a direct PC connect. It does not actually need an arcadevga board. AFAIK. Not sure about the 2 vga connectors.
-
The monitor is a tri-sync, so you can use the JAMMA connector (or are these JVS only?) with your J-Pac and ArcadeVGA to get ALL arcade resolutions OR just use the PC VGA output in 640x480@60 into the monitors VGA 31kHz connector and only use the J-Pac for controls.
More info on the lovely Megalo 410 here: http://www.hard--candy.com/index.asp?page=Megalo+410 (http://www.hard--candy.com/index.asp?page=Megalo+410)
If the cabinet has the JVS wiring standard instead of JAMMA, you should sell your J-Pac and ArcadeVGA and get a JVS-Pac instead: http://jvspac.kirurg.org/ (http://jvspac.kirurg.org/)
-
The monitor is a tri-sync, so you can use the JAMMA connector (or are these JVS only?) with your J-Pac and ArcadeVGA to get ALL arcade resolutions OR just use the PC VGA output in 640x480@60 into the monitors VGA 31kHz connector and only use the J-Pac for controls.
More info on the lovely Megalo 410 here: http://www.hard--candy.com/index.asp?page=Megalo+410 (http://www.hard--candy.com/index.asp?page=Megalo+410)
If the cabinet has the JVS wiring standard instead of JAMMA, you should sell your J-Pac and ArcadeVGA and get a JVS-Pac instead: http://jvspac.kirurg.org/ (http://jvspac.kirurg.org/)
how can i find out whether its the JVS wiring??