Build Your Own Arcade Controls Forum
Main => Monitor/Video Forum => Topic started by: milkit on August 08, 2010, 03:33:56 pm
-
I have three custom made control panels that are designed to be direct replacements on PGA tour cabinets.
I have two with joysticks on the left of buttons and one "left handed special" that has joysticks on the right side of the buttons.
All 3 have two players with 8 buttons each and a recessed trackball cutout. With this, you can put in a trackball mount and it will be flush with the board. I can drill extra buttons for "admin" or whatever for $1 each
All 3 are 5/8" thick and had an offset t-molding slot so that you can use 1/8 inch plexi over the panel and then 3/4" t-molding will be flush.
Bottoms are routed out where joysticks go.
Control panels are $30 for the wood panel only. Add another $30 to add plexiglass to that. Plus actual shipping. I ship flat wrapped in cardboard, the last one i sent was only about $17
The photo of the red and blue panels show what these look like complete and finished. The black one is a different panel I made but it just shows you what it looks like once you put in a trackball mount, puddy it in, and paint over.
(http://img153.imageshack.us/img153/7516/img0366sz.th.jpg) (http://img153.imageshack.us/i/img0366sz.jpg/)
(http://img196.imageshack.us/img196/1241/img0373zx.th.jpg) (http://img196.imageshack.us/i/img0373zx.jpg/)
(http://img36.imageshack.us/img36/2138/img0395fj.th.jpg) (http://img36.imageshack.us/i/img0395fj.jpg/)
(http://img441.imageshack.us/img441/9546/img0396dy.th.jpg) (http://img441.imageshack.us/i/img0396dy.jpg/)
(http://img293.imageshack.us/img293/2351/img0397z.th.jpg) (http://img293.imageshack.us/i/img0397z.jpg/)
(http://img205.imageshack.us/img205/3624/img0400rf.th.jpg) (http://img205.imageshack.us/i/img0400rf.jpg/)
-
crap. wrong section. I am dumb. please delete this.