The NEW Build Your Own Arcade Controls
Main => Audio/Jukebox/MP3 Forum => Topic started by: adgloride on June 19, 2017, 04:51:58 pm
-
I've had this now for a few months. I've started to have problems with it. To cut a long story short I contacted nsm and have been unable to resolve the issue. Now I have decided to fit a pc into the case and take the old one out. I can't find any information on the internet. What I want to know is what I need to use the touch screen. Also some advice on what pc to fit. I want something pretty straightforward to fit. Thanks.
-
AFAIK it uses a zytronic touchscreen. I usually use a SFF PC, it depends on what software you want to run on it.
-
I have an old pentium 4 sff pc I could try and use. The other thing is what LCD board will I need for the zyntronics touch screen. Have all the icon 1s got the same touch screen?
-
So far I’ve stripped down the icon 1 and got the pc to put in it. I’ve also fitted a board, 3 of them to use the touchscreen. I don’t know if it’s because originally I had the monitor lead the wrong way round to the monitor but all I get now is the green light on the board I bought coming on green and then going off and the screen flashing on for a second. I have a feeling I’ve broke the screen. What I want to know is what’s an ideal replacement if I need one. I’ve looked on eBay for a touch screen monitor and they all seem to generate heat.
-
I eventually found out it was my adapter why the monitor didn’t work. The projects coming on nicely the one problem I have now is how do I get my touch screen working again on the icon? I heard you need drivers and I know a circuit board at the back of the monitor runs it. How do I get this circuit board connected up to my pc and working again. Thanks in advance
-
I’ve looked at the schematics of building the cable on the zyntronic website. I’ve got all the things I need and have decided to repurpose the original cable. The problem I’m having are what wires to solder to the serial adapter. I’ve atttached a picture of the molex and serial cable.
https://www.dropbox.com/s/mrl79wyj5skf0b2/2017-10-14%2022.51.18.jpg?dl=0 (https://www.dropbox.com/s/mrl79wyj5skf0b2/2017-10-14%2022.51.18.jpg?dl=0)
https://www.dropbox.com/s/v86g8xunucsa7t1/2017-10-14%2022.52.10.jpg?dl=0 (https://www.dropbox.com/s/v86g8xunucsa7t1/2017-10-14%2022.52.10.jpg?dl=0)
-
I’ve built the cable from the original one provided. But for some reason the touchscreen isn’t working and I’m getting a red light on the board.