The NEW Build Your Own Arcade Controls
Main => Software Forum => Topic started by: hellquib on February 20, 2019, 05:49:59 pm
-
hi everyone
question, i am unable to get any of my controls working in zsnesw with my ipac ulitamte when loaded through hyperspin. any one have any suggestions?
-
Does it work when you open zsnesw outside of Hyperspin?
-
yes the controls do work properly when i run the games straight from the emulator and not hyperspin. any thoughts?
-
Did you setup hyperspin or was it pre-configured for you?
-
i setup hyperspin, have the exe. going to my zsnes emulator but noting. at a loss for what to do..
-
Is zsnes the only emulator you are running through Hyperspin, or are other emulators working OK with it?
Maybe zsnes isn't getting input focus. If there is a mouse attached, then try clicking the mouse after zsnes launches, then see if it accepts input.
-
hey drake
there are other emulators running through mame and they all work fine, but thanks for the reply. let me go try and i will let you know how it worked.