The NEW Build Your Own Arcade Controls
Arcade Collecting => Pinball => Topic started by: tma on September 11, 2014, 05:39:20 pm
-
Hello,
Was wondering if someone with a real Pinball machine would kindly take a couple of measurements for me.
Need measurement of top of glass/metal edge trim down to center of button & front edge to center of button (flipper button).
Best explained in the picture below:
(http://i239.photobucket.com/albums/ff249/thomas3120/My%20MAME%20Arcade%20Cabinet/Pinballbuttonloc_zps15f05787.jpg) (http://s239.photobucket.com/user/thomas3120/media/My%20MAME%20Arcade%20Cabinet/Pinballbuttonloc_zps15f05787.jpg.html)
Need measurements X & Y
Thomas
-
This is what I came up with while researching for a pinball controller. (see sig)
The flipper buttons could be a little bit closer, but no closer than 36.5mm center to center.
(http://forum.arcadecontrols.com/index.php?action=dlattach;topic=103207.0;attach=249913)
Don't just assume these measurements are good for your application -- verify whether the button positions are comfortable for you at the height and angle of your cab.
Scott