The NEW Build Your Own Arcade Controls
Main => Woodworking => Topic started by: Panther7 on March 03, 2019, 02:07:31 pm
-
I know most people here use plywood or MDF, but I have a special project that won't be using vinyl. Does anyone have any experience working with something like a Butcher Block or solid maple? Any special issues I should keep an eye out for (such as special tools or bits), or will it work as shown in online guides meant for MDF?
I know my finishing, just curious about the cutting/joining aspects. I made a desk out of Maple Butcher Block, and now I want my pedestal to match.
-
I'm a big fan of using a Kreg jig + wood glue to join things at 90 degrees. Is this the info that you are looking for?
-
I just think it's funny a question about Butcher Block (think counter tops) is being answered by processed meats :laugh2:
-
The glue slobber won't stain evenly and will have to be removed, to keep it flat a planner will take it down in as little as 1/32" shaves so you may want to start with someting a little beyond your target 3/4"...A solid piece (IMO) should be resurfaced too, you would be suprised at the difference in surface inperfections and flatness of a otherwise nice board goes...A belt sander can be used in both cases but will take longer and is still going to take considerable meat from your workpiece.
-
A 3/4" panel of solid wood/butcher block *may* have dimensional stability issues... i.e. cupping and warping, etc..
Make sure to put a finish coat (poly) on both sides to keep it flat.
Other than that - sharp tools - all the joinery is the same as MDF... the wood is just a lot harder so sharp tools are a necessity..