The NEW Build Your Own Arcade Controls
Main => Raspberry Pi & Dev Board => Topic started by: thebrokenjoystick on August 28, 2018, 10:18:31 pm
-
Maybe this has been posted before, if so, sorry for the dupe...
Working on my icade->Retropie project and needed a cheap and easy way to mount the monitor driver boards. Went to the local Dollar tree to see if I could make something work and came across these command strip knockoffs - 9 for $1 and they work perfectly. I took off the command strip and just used hot glue instead. Cheap and easy.
-
Good Idea and thanks for sharing. I usually get some nylon washers from the hardware store and use screws. If really cheap and dont want to go to the store ill cut up a old BIC pen and use those as the spacers.
-
Wow - those are great ideas too! Thanks!
-
I use these: https://nl.aliexpress.com/item/MTGATHER-100-PCS-HC-5-Nylon-Plastic-Stick-On-PCB-Spacer-Standoff-Locking-Snap-In-Posts/32794726696.html
-
I use these: https://nl.aliexpress.com/item/MTGATHER-100-PCS-HC-5-Nylon-Plastic-Stick-On-PCB-Spacer-Standoff-Locking-Snap-In-Posts/32794726696.html
I saw those on Amazon and considered those but they were all ~$7+. They look like they would work though.