The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: foreverlastd on August 17, 2009, 12:28:39 am

Title: Wiring Tact Switches to Xbox 360 Triggers
Post by: foreverlastd on August 17, 2009, 12:28:39 am

Hi there, I'm building a custom made Xbox 360 arcade stick and I'm hung up on wiring up the triggers. I've looked around and couldn't find the answer I needed. I just need to see how the tact switches need wired and where (if needed) the resistors are attached. I attached an image to the topic. If you could just draw the connections (and resistors).

Thanks
-Mike

Title: Re: Wiring Tact Switches to Xbox 360 Triggers
Post by: HaRuMaN on August 17, 2009, 09:08:30 am

What controller are you using?  (MadCatz, Wireless, Wired Official, etc).

Title: Re: Wiring Tact Switches to Xbox 360 Triggers
Post by: foreverlastd on August 17, 2009, 10:54:20 am

Quote from: HarumaN on August 17, 2009, 09:08:30 am

What controller are you using?  (MadCatz, Wireless, Wired Official, etc).

It's the official wireless controller.

Title: Re: Wiring Tact Switches to Xbox 360 Triggers
Post by: HaRuMaN on August 17, 2009, 11:23:33 am

Quote from: foreverlastd on August 17, 2009, 10:54:20 am

Quote from: HarumaN on August 17, 2009, 09:08:30 am

What controller are you using?  (MadCatz, Wireless, Wired Official, etc).

It's the official wireless controller.

Is it the older, non-common ground PCB, or the newer common ground PCB?

Title: Re: Wiring Tact Switches to Xbox 360 Triggers
Post by: foreverlastd on August 17, 2009, 06:22:33 pm

Quote from: HarumaN on August 17, 2009, 11:23:33 am

Is it the older, non-common ground PCB, or the newer common ground PCB?

I can't look at the physical controller at the moment (as it's 130miles away) but I know it's the same design as this one ( http://www.instructables.com/files/deriv/FLR/BM3T/FIN3ZDRY/FLRBM3TFIN3ZDRY.MEDIUM.jpg ) .

Title: Re: Wiring Tact Switches to Xbox 360 Triggers
Post by: foreverlastd on August 19, 2009, 06:29:09 pm

*Bump*