The NEW Build Your Own Arcade Controls
Main => Raspberry Pi & Dev Board => Topic started by: arad_123 on December 09, 2017, 06:00:33 am
-
i just finish to wire the buttens on my arcade machine.
i got coin and 1\2 player butten that i put them on control panel.
how do i configre them on the pi ?
-
It depends on the software you are using. You'll have to add some more info to the thread to get better feedback.
-
If youre using retropie, youll probably have to set up the "buttons" (coins are buttons too though you use coin to "press" button) from game. (pressing TAB if remember correctly). Add more info and youll get fast help from the wise ones here like 1500points wrote :). Hes one of them ;D.
-
When you setup controls in RetroPie you should set "start" to player 1 button and "select" to coin for player 1 (for the P1 controls). Same goes for P2 of course.