Recent Posts

bubble wrap

box in a box

I just unboxed it. the creases in the old cardboard  was stiff. just like a new book. pics will be coming soon.
yes I am excited about it. from my research . It will be close to a Pi 4 BUT it can run windows!

I trust your input Randy. thank you

who s the oldest person here.
I am 59 born March 18th 1965

My tiny client came in today.I have not unboxed it yet.
question. Would you replace thermal past right away? i am torn on this. 1 it has never been powered on. 2 it is over 10 years old.

The big killer is usually heat, but age (drying out) will do it too.  If you are concerned, pull the heatsink and take a look. If it's still gooey, just put back.  Otherwise, clean well and replace.

Thanks for the info Randy, I ended buying the Creality V3 KE. My discount to myself was generous 

Reprinted a few parts for my project with some improvements.  I'm happy with the results:

Spiffy!  So, on the webs, did you tweak some things to deposit like that or were there more manual artistic shenanigans used?

It came in today. Still unboxed. I am downloading multi OS systems to try.
tiny window 7, tiny win 10, tiny win 11, androids, Linux, Batocera. to try booting from thumb drive fist.

My tiny client came in today.I have not unboxed it yet.
question. Would you replace thermal past right away? i am torn on this. 1 it has never been powered on. 2 it is over 10 years old.

So if you run the hard drivin compact roms, you should be able to successfully calibrate the wheel, but you must use a mouse. Moving the mouse for ages to the right will simulate 4 wheel rotations and the calibration should report:
    NEW CNTSPTRN 1024 PATCEN 0

Thus one complete wheel rotation amounts to 1024 (0x400) encoder values.

Note. You might want to hold the left shift key to get the encoder value spot on at the end of the calibration (when its working out the PATCEN thing).

In the game, the centre edge bit (That "result ^= 0x4000" stuff) will 'latch' each time the wheel does a full rotation (reaching its centre point). The encoder wheel value at these centre points will be one of 0x000, 0x400, 0x800 or 0xC00.

I think that just as your car re-spawns is the moment when the game works which one of the centre points is the most appropriate (nearest). Let say you started the game around the 0x800 position, then you crash after turning hard right (and say the encoder at that moment is 0xD50). Then once you re-spawn, the game doesn't expect you to wind back the steering all the way to the 0x800 centre point (0xD50-0x550 encoder values), you'll only be expected to wind back the steering to the 0xC00 centre point (0xD50-0x150 encoder values).

So now after you crash, when you get the car to go in a straight forwards direction and observe the encoder value (left shift), you should notice it'll always be around one of those those centre points (0x000, 0x400, 0x800, 0xC00). The game does have to be correctly calibrated in the service menu for this to work accurately.

I hope that what is happening!