The NEW Build Your Own Arcade Controls
Main => Main Forum => Topic started by: javeryh on May 18, 2018, 11:02:47 am
-
How much space do I need under a CP for a ServoStik assuming I bottom mount it? Thanks.
-
Just measured mine and it was about 1 3/4 inch or about 45mm. I replaced the restrictor plate screws with longer ones so you might be able to do 1 1/2 inch if you want it really snug.
-
Just measured mine and it was about 1 3/4 inch or about 45mm. I replaced the restrictor plate screws with longer ones so you might be able to do 1 1/2 inch if you want it really snug.
Thanks a lot. I may need to make some design changes now! I have about 1-3/4" total right now to work with but probably don't want to cut it that close.
-
Worth the effort. I was quite chuffed with mine (",)
-
Worth the effort. I was quite chuffed with mine (",)
yeah - I've read nothing but good things. I'm probably only going to have 50 or so games in this cab I've been kicking around but it will be a mix of 4-way and 8-way and vertical and horizontal games so this joystick seems like the best solution...
-
Worth mentioning that they may need a little attention out of the box. I wrote about mine at the end of this thread:
http://forum.arcadecontrols.com/index.php/topic,132157.msg1521798.html#msg1521798 (http://forum.arcadecontrols.com/index.php/topic,132157.msg1521798.html#msg1521798)
-
Worth mentioning that they may need a little attention out of the box. I wrote about mine at the end of this thread:
http://forum.arcadecontrols.com/index.php/topic,132157.msg1521798.html#msg1521798 (http://forum.arcadecontrols.com/index.php/topic,132157.msg1521798.html#msg1521798)
Thanks - I'll definitely keep this in mind when I install my stick. Very helpful! :cheers:
-
So.... the ServoStik is supposed to come with the motor, right? Mine showed up blank. The restrictor plate was there but not the motor.
Edit: Never mind. Andy took care of it!