The NEW Build Your Own Arcade Controls
Main => Main Forum => Topic started by: Wzrd0803 on March 25, 2020, 07:42:37 pm
-
I was given a Happ trackball by bobbyb13 (Thank you so much!). It has a six pin Molex connector and green boards.
If I get an Optiwiz 3 and the GGG no solder cable, is that all I need for my arcade cabinet with MAME to use the trackball?
-
I was given a Happ trackball by bobbyb13 (Thank you so much!). It has a six pin Molex connector and green boards.
If I get an Optiwiz 3 and the GGG no solder cable, is that all I need for my arcade cabinet with MAME to use the trackball?
Yes, but you might want to upgrade to red boards, too.
According to the Happ Trackball FAQ (https://na.suzohapp.com/wp/frequently-asked-questions.p?S=Trackballs), pinouts are the same for the old green boards (A052-1010-00) as the new red boards. (A052-1011-00)
What are the pinouts of the Optic Sensor pcb A052-1010-00 and A052-1011-00 used on the trackball or trackwheel or 360 steering wheel ?
These alll use the same Item # A052-1011-00 Optic Sensor Board. The connections are as follows.
Pin 1 - Output A
Pin 2 - +5V
Pin 3 - GND
Pin 4 - Output B
Scott