The NEW Build Your Own Arcade Controls
Main => Woodworking => Topic started by: tfity on October 03, 2018, 07:48:05 pm
-
On my control panel I may have off-centered the t-molding cut with the router slightly. Its like 1/8-inch off from center. I took me about an hour to make the main cuts and I really don't want to do it again. Can I just make the gap bigger and put some wood glue or Bondo in the cut to make the t-molding stick? Or am I screwed?
Appreciate the responses!
-
No worries, Same thing happened to me. Simply tape off the off centered area and use bondo filler. Then reroute your Tmolding groove. After applying your Tmolding no one will be the wiser.
-
Holy ---steaming pile of meadow muffin---. Didn't even think of that. Thanks!