The NEW Build Your Own Arcade Controls

Main => Main Forum => Topic started by: falkensmaze on January 16, 2018, 05:03:39 am

Title: iPac programing
Post by: falkensmaze on January 16, 2018, 05:03:39 am

Hi all its good to be back its been a while since tinkered with my cab hence im a bit rusty, basically i am trying to update my ipac to add two new keys for NES saves and loads but im getting driver failed message. I installed the latest ipac software to see what that would do but i get a picture stating "no board" The previous controls are working fine in mame gameex etc what am i missing?? Thanks  8)

Title: Re: iPac programing
Post by: Titchgamer on January 16, 2018, 06:39:49 am

Is it a really old Ipac?
It may not be compatible with the newer software?

Think I read that somewhere once upon a time lol

Title: Re: iPac programing
Post by: UEDan on January 16, 2018, 12:12:51 pm

My old iPac is not compatible with Windows 10.
Since I no longer run Windows 7 at home I had to use my Mavericks Macbook. That works.

https://www.ultimarc.com/download_old.html (https://www.ultimarc.com/download_old.html)

Title: Re: iPac programing
Post by: AndyWarne on January 16, 2018, 05:41:18 pm

If you only need to change or add a few keycodes you can try this method:

http://www.ultimarc.com/interact.html (http://www.ultimarc.com/interact.html)

Andy

Title: Re: iPac programing
Post by: falkensmaze on January 16, 2018, 06:03:13 pm

Thanks Andy i will try that later. BTW I just emailed u so please ignore  ;D ;D