| Main > Main Forum |
| Trackball question, rusty bearings ? |
| << < (3/6) > >> |
| spystyle:
Hi Randy :) I just brought the Imperial bearing to my local hardware store and amazingly I found a match. The label on bearing from the hardware store reads: .250 ID .625 OD .1960 width "precision ball bearings" But I didn't buy them because they were insanely expensive. What are the dimensions of the Happ bearings? |
| RandyT:
--- Quote from: spystyle on January 19, 2010, 10:35:22 am ---What are the dimensions of the Happ bearings? --- End quote --- The bearings are the same. It's the rollers that differ between the HAPP and Imperial models. RandyT |
| spystyle:
OK thanks :) |
| SirPeale:
You can probably loosen those right up by drenching them in 3-in-1 and spinning them with a drill. It'll break that rust right up. Then flush it out with a solvent (which one is your choice, as long as it doesn't leave a residue) and put one more drop of 3-in-1 on and spin again to lube it up. |
| spystyle:
I'll have to pick up some 3-in-1 and try that, thanks :) |
| Navigation |
| Message Index |
| Next page |
| Previous page |