| Main > Main Forum |
| Rotate Happ Trackball axis 90 degrees |
| << < (2/2) |
| SirPeale:
--- Quote from: csa3d on December 05, 2009, 05:18:15 pm ---i did a similar mistake on my trackball, i ended up swapping the boards then snipping the wires attatched them and swapping them. -csa --- End quote --- Why didn't you just pop the pins out of the Molex connector and pop them back in? Which is the next thing I was going to suggest to the OP. |
| csa3d:
--- Quote from: SirPeale on December 06, 2009, 10:57:37 pm --- --- Quote from: csa3d on December 05, 2009, 05:18:15 pm ---i did a similar mistake on my trackball, i ended up swapping the boards then snipping the wires attatched them and swapping them. -csa --- End quote --- Why didn't you just pop the pins out of the Molex connector and pop them back in? Which is the next thing I was going to suggest to the OP. --- End quote --- That probably would have felt less destructive! Swap the molex pins instead of performing wire surgery and your problem should be resolved. -csa |
| mikeyv23:
I ended up recutting the trackball mount area of my control panel. I didn't have to redo the whole thing, and in the end I guess it was easier. Thanks for the suggestions! |
| Navigation |
| Message Index |
| Previous page |