| Main > Main Forum |
| Extremely stupid grounding question (JPAC). |
| << < (2/3) > >> |
| BobA:
From the Ultimarc site Check grounding of the cabinet before proceeding to avoid any danger/damage. The best method of doing this is as follows: Using an ohmmeter or continuity tester check for a good connection between the following points: Monitor frame JAMMA edge connector ground pins. These are the 4 pins at either end of the connector. Mains power cord ground. Control panel ground. Power supply ground if fitted. |
| chairhome:
I read that, but I read it as saying that those points on the cabinet need to be grounded... |
| CheffoJeffo:
If you are grounding your controls to the grounds on the JAMMA connector, you are fine. |
| chairhome:
Thanks, so does that mean I have a different problem with my jpac controls not working? |
| CheffoJeffo:
Do you get any lights on your JPac ? Can we see a picture of your wiring ? |
| Navigation |
| Message Index |
| Next page |
| Previous page |