Main > Main Forum
how are y'all hooking up DC with IPAC?
(1/6) > >>
Frostillicus:
Apparently there are issues when you use the same set of controls with an IPAC and a Dreamcast gamepad hack.   I have problems with first the DC working, then the IPAC doesn't work, but then the DC doesn't work, etc....

Does anyone have a solution to this?  Or how about a success story with a different keyboard encoder?  Like the keywhiz or the MK64?

I saw this thread on the newer ultimarc board...but didn't understand how to implement their suggestions for two sets of controls (for 2 players)...

Thanks... :)  

SNAAAKE:

--- Quote from: Frostillicus on July 20, 2003, 02:13:46 am ---Apparently there are issues when you use the same set of controls with an IPAC and a Dreamcast gamepad hack.   I have problems with first the DC working, then the IPAC doesn't work, but then the DC doesn't work, etc....

Does anyone have a solution to this?  Or how about a success story with a different keyboard encoder?  Like the keywhiz or the MK64?

I saw this thread on the newer ultimarc board...but didn't understand how to implement their suggestions for two sets of controls (for 2 players)...

Thanks... :)  



--- End quote ---
get some molex connector.
gotta switch manually.takes only a second.
I got my molex connector from bobroberts.
Get the picture ?



I-pac=male molex connector.
                                                       >>> Joystick,buttons=female molex connector.


dc interface=male molex connector.



Frostillicus:

--- Quote from: SNAAAKE on July 20, 2003, 02:22:13 am ---
--- Quote from: Frostillicus on July 20, 2003, 02:13:46 am ---Apparently there are issues when you use the same set of controls with an IPAC and a Dreamcast gamepad hack.   I have problems with first the DC working, then the IPAC doesn't work, but then the DC doesn't work, etc....

Does anyone have a solution to this?  Or how about a success story with a different keyboard encoder?  Like the keywhiz or the MK64?

I saw this thread on the newer ultimarc board...but didn't understand how to implement their suggestions for two sets of controls (for 2 players)...

Thanks... :)  



--- End quote ---
get some molex connector.
gotta switch manually.takes only a second.
I got my molex connector from bobroberts.
good luck ! :)

--- End quote ---

molex? you mean like on a PC power supply?
SNAAAKE:
something like this would do.


http://www.dameon.net/BBBB/conectas.html
I dont use i-pac so I am not sure how many inputs but you can always use 2x24 pin connectors(if 24 isn't enough).

I use these though.


SirPoonga:
are printer switchbox would work if that is enough pins.
Navigation
Message Index
Next page

Go to full version