| Main > Main Forum |
| Need dimensions of Apache Blackhawk Push-Pull Spinner, please! |
| (1/1) |
| jasonbar:
http://www.apachecontrols.com/store/index.php?main_page=popup_image&pID=3 Howdy- I shipped off my Blackhawk spinner knob to a friend to see if he can laser engrave a design onto the small cap on the top. I then realized that I could aso whip up some artwork to go around the upper conical face. Since I don't have the spinner in hand at the moment, could somebody pretty please measure the following? 1 - diameter of the flat cicle on top 2 - diameter of the knurled large diameter Thank you very much! -Jason |
| jasonbar:
FYI: Apache responded. 1 - diameter of the flat circle on top = 0.765” 2 - diameter of the knurled large diameter = 1.765” Thanks, -Jason |
| jasonbar:
Aaaaaand, the results! Check out my other anodized & engraved spinner knob & steering wheel hub too: http://s242.photobucket.com/albums/ff97/infernolab/Arcade%20Game/?start=all Thanks, -Jason |
| Navigation |
| Message Index |