Main > Main Forum
AIMTRACK installation in Guncon, need help with PCB
<< < (2/3) > >>
DJ_Izumi:

--- Quote from: ammitz on October 28, 2009, 02:16:06 pm ---PM me your adress and I'll mail it to you
--- End quote ---

I -think- I just successfully PMed you.  Lemme know if I failed. :X
RandyT:

The answer here is to disregard the GunCon board entirely.  In this particular instance, the "common" is where you decide it should be.  These are simple SPST switches, which means the action is nothing more than bridging those wires you see coming from the boards.

Tie one side of each of them together and that's your common.


RandyT
ammitz:
TY very much for your quick reply :)

IT WORKS ;)

I'll put up some pictures later.
bkenobi:
My mistake.  I thought you were looking at the bottom of an AimTrak board.  Obviosly, the giant NAMCO logo should have clued me in that I was looking at your question wrong.   :banghead:
TeutonicDarkness:

--- Quote from: ammitz on October 28, 2009, 03:08:37 pm ---TY very much for your quick reply :)

IT WORKS ;)

I'll put up some pictures later.

--- End quote ---

 How about them pictures?   ;)


I'm going to install the Aimtrak in a guncon myself.
Well that is when my guncons arrive.

So any detail will help!


Navigation
Message Index
Next page
Previous page

Go to full version