| Main > Main Forum |
| Installed my AimTrak into a Beretta Gun |
| << < (2/4) > >> |
| Beretta:
ah a man after my own heart, good choice ;D looks like you did a good job, although bkenobi is right you could probably just removed the sensor and ran a wire to and from, secure it in the barrel with some hot glue & stash the PCB in the grip. tidbit that gun is modeled after a 92/96 (9mm/.40) Brigadier (brigaider had heavier slide "wavy hump"), although the brigadier also came with finger groove wrap around grips.. that guns got regular 92/96 grips so not completely accurate. |
| TheShanMan:
Very nice! My preference (cost aside) would be for an arcade accurate gun, but among the non-standard choices I've seen people post so far, this one is the winner in my book. |
| Neverending Project:
Keep in mind that if you remove the camera from the board you would probably need to keep the same angle and tilt (the same as it is currently mounted on the PCB) because the calibration routines are designed around this. |
| Ginsu Victim:
Yeah, the tilt and angle are definitely important. I thought mine was messed up at first, but then I looked at it closely and realized it was like that on purpose. |
| wolfsoft:
no wonder, when I see you forum name *smile* ;-) --- Quote from: Beretta on October 21, 2009, 12:52:59 pm ---ah a man after my own heart, good choice ;D --- End quote --- |
| Navigation |
| Message Index |
| Next page |
| Previous page |