Main > Main Forum
Installed my AimTrak into a Beretta Gun
(1/4) > >>
wolfsoft:
Hi Folks,
today I found some time to put my AimTrak into a Beretta Gun from Thrustmaster (original for xbox).
It was a hard work, because I must cut of a lot of the pcb to fit into the gun head.

Here you can find detailed picture gallery if you want


syph007:
Nice work!  I would have been nervous to shape the pcb, but it looks like you did a careful job on it.
wolfsoft:
For shrinking I must remove two wires (rebuild them) and removed a Resistor and Capacity at the Camera PCB.
drventure:
Nicely done.  :applaud:

That gun looks incredible.
bkenobi:
Would it be possible to alternately remove the IR detector board and mount that in the gun tip instead of doing it this way?  As long as the components are there, this way should work.  I'm just thinking it could be installed in a tighter spot if the small board could be connected via leads.  Shoot, if that were possible...you could grind down the board even further and fit it in a .22 barrel!   :laugh2:
Navigation
Message Index
Next page

Go to full version