Arcade Collecting > Pinball

pop bumper stays activated

(1/2) > >>

pinballwizard79:
as soon as I power up the machine the pop bumper kicks down & stays down (gets hot of course)

wtf?

any ideas?

Jeff AMN:
Your switch is out of adjustment and the leafs are touching. You'll just need to lift your playfield and bend back the bottom leaf a touch. You do want them to where they're very close to touching, so don't adjust it far.

ChadTower:

Or the driver transistor is shorted dead.

ChadTower:

--- Quote from: pinballjim on October 09, 2009, 09:32:34 am ---Or he's got a bad pop bumper driver board... etc etc

Game title always helps on threads like this...

--- End quote ---


Yeah, I just went with the widest one.  Game title is key for a specific diagnosis.

pinballwizard79:
---steaming pile of meadow muffin---, I cant believe I didnt say it before: Tales from the crypt.

Its not the leaf switch, I can pry back on that puppy & look through it...I even looked to see if something was arcing across the switch.

I think it is board related, or some part on the board I mean... or something other than the obvious broken wire, short & etc.

Damn I hate pinball

Navigation

[0] Message Index

[#] Next page