| Main > Main Forum |
| Who is a reputable PCB repair person |
| (1/1) |
| YoGaBaR:
I have checked the wiki and I have seen a few options. I NEED a person that can fix my Bubble Bobble - repeats on the warning screen Bubble Symphony - dead game and mobo Bubble Memories - gets sound but frozen pic I have had a guy locally fix them all and said they worked and had them on for an hour and said everything was fine. Now I test them and all these problems. Plus I am too pissed3d to check my other games to see if they are really working or not. I want to know who would be the best to fix an old Taito and Taito f3 system. I need a reputable person, company, or member here who will really fix them and not screw me. I really need these done for they are part of a project I am in the midst of creating. Thanks, YoGaBaR |
| CheffoJeffo:
My number one recommendation for JAMMA-based stuff would be BYOAC member channelmaniac, who can be found in the Vendors page of the wiki under ArcadeComponents.com. I only have one of his repaired boards, but the repair is neat and clean and the board works great. I have ordered chips from him before and also read through his repair logs (here and here) a number of times and found them very helpful. Before I would go that route, however, I would do the mandatory voltage and connector checks to make sure everything is OK (it isn't clear from your post how much troubleshooting you have done to date). |
| Kevin Mullins:
--- Quote from: CheffoJeffo on October 04, 2009, 08:54:24 pm ---Before I would go that route, however, I would do the mandatory voltage and connector checks to make sure everything is OK (it isn't clear from your post how much troubleshooting you have done to date). --- End quote --- Agreed......... Do you have ANY boards that work in the same setup you are trying those three boards? What's your power supply putting out when a board is plugged in ? When I see or hear of that many boards said "working" and none of them work in the same setup, I question the setup first. |
| YoGaBaR:
I guess I did the basics of testing. I have put the boards in my TMNT cab I know its working. same problems. I have also made a little jamma testing bartop top test boards. Same problems. I have tested other working boards on both cabs. I even took the bubble symphony and bubble memory carts and put them on the others motherboard. They are both Japan version carts and motherboards so I know they are interchangeable. Other than that all I can say is that the bartop I made is all new components and I know I have tested six working boards on it. Some jamma and some not. Thanks for the replies, hope this info helps. |
| Navigation |
| Message Index |