Main > Main Forum
Another Ultimarc ArcadeVGA will not install thread pictures !
<< < (2/2)
Finchbyrd:
Mine works fine and has since I got it. I just had problems the first night because the motherboard was still the primary source of video and the card didn't like that. My first post seemed smug so I appologized, I was aggitated at something unreleated.
ctozzi:
Ok so i finally got a bit of luck last night, I reinstalled the card again, after running the utility to remove any drivers. Also I hooked it up to my wells gardner monitor and barely readable install steps. I had to force the driver through the device manager and update the driver. So now it works but my monitor vertiacl sync pot will not stop the screen from rolling. I can get it almost stopped but it still rolls. I think i will have to search for a new pot board and see what happens. Or i will swith monitors from another cabinet.
AndyWarne:
Perhaps the problem is a connection issue between the card and monitor, ie V Sync not connected?

About the install, the instructions on www.ultimarc.com/avgainst.html do go through the process of installing the driver from Device Manager. This is always necessary if the PC is in safe mode since the ATI install program will not run in safe mode and gives exactly the errors shown in the screenshots. This is a shame but unfortunately an issue with the ATI installer which admittedly is not the best.
Navigation
Message Index
Previous page

Go to full version