Main > Reviews

Whiteside 1/16" Slot Cutter from T-molding.com

<< < (7/7)

MKFan4Life:
They should really just etch "Upside Down STUPID" on the appropriate side to get the installer's attention, eh?   :laugh2:

kahlid74:
At first I was like what in the world, my bit works fantastic and doesn't burn at all and then I saw the original poster put it on wrong and I was like:

johncl:
A question to you slot-cutting-experts out there. ;)

I have 11mm (0.433071 inches) MDF which I am building my bartop in, is that too thin for 1/16" slots for t-molding to be fit? Just afraid that it might split the MDF or something and wonder if I should just perhaps paint the edges in white glossy paint to make it "look" like t-molding (Nintendo used flat t-molding from what I have learned so I could probably get away without profiling them).

Navigation

[0] Message Index

[*] Previous page