Main > Reviews
Whiteside 1/16" Slot Cutter from T-molding.com
TBullet:
Can you use this slot cutter on both 1/4" and 1/2" shanks?
Franco B:
I'm not entirly sure what you are asking.
The arbours are availiable in two shank sizes, 1/4" and 1/2".
T-moulding sell the A200B arbour which is for use with a router with a 1/4" collet.
If you want a Whiteside arbour with a 1/2" shank you need the A210B or A220B. The difference between them is the overall length. The A210B is 2 3/8" long whereas the A220B is 4" long. The A210B 2 3/8" version will be more than adequate for everything you want to build cab wise.
The slot cutters have a 5/16" bore so you can use the cutter if you already have a 1/2" arbour with a suitable spigot.
korbitz:
--- Quote from: shponglefan on September 29, 2009, 11:37:36 am ---
That's okay, I think I did the same thing. So at least you have company. ;D
--- End quote ---
Company?, getting near a crowd, just looked at me slot cutter and yup it was the wrong way round also, luckily it doesn't look damaged, just a bit burnt looking. I always wondered why my smoke alarm kept going of in the house when i cut some wood indoors :banghead:
Franco B:
Errm, well, cough cough, I have never done that, honest guv :angel:
(Makes a lovely smell doesn't it :-[ :laugh:)
korbitz:
--- Quote from: Franco B on April 02, 2010, 03:17:19 pm ---Errm, well, cough cough, I have never done that, honest guv :angel:
(Makes a lovely smell doesn't it :-[ :laugh:)
--- End quote ---
Makes an even lovelier smell when you dont wear a facemask and the little burnt bits do wonders for the eyes when you dont wear goggles either ::)
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version