Main > Main Forum
U360 Joystick: Why can't I get the PCB to fit over the octagonal restrictor????
<< < (2/4) > >>
Triangel7D:
I think Andy's octagonal restrictor is custom-made. It's a lot different than the JLF restrictor (Sanwa  GT-Y Octagonal Restrictor Plate).  Scroll down to the listing on this page:

http://www.lizardlickamusements.com/pages/joysticks.shtml

Ginsu Victim:
I've never seen one up close. I was just going on the fact that you're not alone in having problems getting the thing on.
Ginsu Victim:
I just looked at the pics vs the ones on ultimarc's site and there is a clear difference.
Triangel7D:
It's funny -- it was the octagonal restrictor for the JLW that introduced me to the U360. I love the JLW, and always wanted the octagonal restrictor like the JLF's have.
severdhed:
i installed one on my u360, i managed to break one of the shafts because it would't thread in properly.  even after i got those issues resolved, i only ended using the restrictors for about 5 minutes because i hated the feel of it.
Navigation
Message Index
Next page
Previous page

Go to full version