Main > Lightguns
Its Here: Ultimarc AimTrak Light Gun Module
isucamper:
Andy. You are my hero.
AndyWarne:
--- Quote from: DeLuSioNal29 on September 17, 2009, 03:05:19 pm ---Question for Andy. Will this interface work with Area 51 guns? I have a couple sitting in my garage.
Thanks!
DeLuSioNaL29
--- End quote ---
Umm well its not actually an interface. Its a complete module. As to whether it will fit inside the gun, I think all arcade guns should have a large enough barrel.
Epyx:
Basically with what Andy is providing you could palm an arcade button (triggered with your thumb) that is wired to the gun portion of the interface and tape it around your hand for a gun on the cheap :laugh2:
Or build/use a shell that looks decent... ;)
AndyWarne:
--- Quote from: Ginsu Victim on September 17, 2009, 03:16:59 pm ---I was also wondering about the off-screen reload and how it's handled...
--- End quote ---
Good question. Actually its not physically possible to move a mouse pointer outside the screen co-ordinates so I have no idea how this works. I can only assume it really means reload is "very near the edge of the screen".
Basically it should work if a mouse works. But if there is any special change needed the firmware is upgradeable so I can make changes if required. In fact to be honest I would expect tweaks will be needed as it the case with all new products.
I agree a video would be a great idea. I will look at this possibility.
On the subject of multiple guns, all guns will control the same mouse pointer, but software which reads the devices using DirectInput is able to read each device independently. Mame can do this.
Ginsu Victim:
Finally took the time to read the whole page for this new product and I'm flipping out wanting one (or two!). Sounds like you might have a winner, Andy. :cheers:
Navigation
[0] Message Index
[#] Next page
[*] Previous page
Go to full version