| Main > Main Forum |
| Lighting coin door |
| (1/7) > >> |
| BrianP:
I have the Happ coin door for my cabinet: http://happcontrols.com/pc/accessories/40071300.htm It has no mech (which is fine) or lights (bummer). I was hoping to put some lights behind to coin slots for looks. Any idea how? I would rather not have to get another controller just for this. Don't care too much if they blink or not when coins are added. Perhaps get a lighted case fan and rip the lights out of it? There has to be a better way, right? - brian |
| Franco B:
Just wire up a couple of LEDs to a spare molex etc from your PC and point them at the rejects. I'm not sure why you would go to the trouble of mounting a coin door to your cab when you can't even put coins in though. ??? |
| Ginsu Victim:
--- Quote from: Franco B on September 15, 2009, 10:40:45 am ---I'm not sure why you would go to the trouble of mounting a coin door to your cab when you can't even put coins in though. ??? --- End quote --- For the genuine look. |
| BrianP:
--- Quote from: Ginsu Victim on September 15, 2009, 10:50:54 am --- For the genuine look. --- End quote --- That is exactly why I did it. It looks cool and didn't cost too much (relative to the entire project). Any idea where to get a couple of LEDs? I would have no idea about the amp/watt/resistance requirements... - brian |
| Ginsu Victim:
Radio Shack. I just steal power from my PC PSU. |
| Navigation |
| Message Index |
| Next page |