| Main > Main Forum |
| Mounting hole sizes? |
| << < (2/2) |
| BrianP:
--- Quote from: Franco B on September 09, 2009, 10:58:29 am ---[Thread about cutting TB holes] Are you using dust washers on top of your panel? If so your 28mm bit will be fine as the dustwasher will cover it. I personally would use a 20mm bit but that's only as I have one to hand. --- End quote --- Ultimarc shipped 2 plastic covers for the joystick hole (which I assume is called a dustwasher, <sigh> such a newbie), so I should be fine there. After all the money I have spent on this, a couple more for a 20mm hole saw won't phase me. - Brian |
| Haterot:
if that's the case get custom washers made. Ask the guy above. |
| BrianP:
--- Quote from: Haterot on September 09, 2009, 01:18:36 pm ---if that's the case get custom washers made. Ask the guy above. --- End quote --- Why would I need custom washers? The ones from Ultimarc are larger than the 20mm. I don't think any of the hole will be exposed even when the joystick is at the far end of it's throw. I am new to all of this and need lots of hand holding. - Brian |
| Navigation |
| Message Index |
| Previous page |