Main > Main Forum
Act Labs Light guns and Calibration Issues
(1/3) > >>
DigitalAce7:
Hi,
My problem is this: I have 2 Act-Labs Light guns and whenever I try to calibrate them, they stop working completely after calibration.  The cursor jumps to the same spot no matter where I point the gun.  If I reset the computer or just unplug the usb and plug it back it, they work ok until I try to calibrate them again.  It seems like the calibration isn't working at all.  Has anyone had a similar experience and fixed it?  Thanks in advance,

    - DigitalAce7 
DynamiteSJ:
any word on this? i am interested in buying one of these
BamBam:
I have purchased two and have yet to get them to work with my MAME/MALA setup on WinXP.
I hold off on any negative comments until I have had time to mess around with it further.
DynamiteSJ:
what kind of a monitor are you using?
DigitalAce7:
I am using a Wells Gardner D9800 monitor.  It is behind plexiglass also in my cabinet.  But it works well just off about an inch.  It's only after calibrating that it doesn't work.  Any theories??
Navigation
Message Index
Next page

Go to full version