| Main > Main Forum |
| 'Ghost' Key Presses |
| (1/2) > >> |
| Klomper:
I have almost completed my conversion of a nonworking NARC to Mame (will hopefully update my project page soon), with everything up and running and just doing some final setup and cleanup. In the testing I have found that I am getting some ghost key presses. I had this almost identical setup in a 'temporary' panel for over a year and never had a problem. ??? I hoping people can point me in the right direction of what to check so I don't waste to much time trouble shooting. Here is hopefully all the relevant information 1. IPAC-2 PS/2 2. 2 joys/w 7 buttons, 2x coin, P1/P2 start, ESC and Pause 3. Happens at least one time a game in 1942 (random loop) or other shooters where a bomb is randomly released. Did not notice a problem in NBA Jam or TMNT. 4. Windows XP 5. Stripped CAT 5 for the wiring (new to this setup) 6. All noticed random presses have been P1 B2 except one time it was Pause. So far I have: 1. Resaved my configuration to the IPAC 2. Made sure P1 B1/B2 wires did not have contact. |
| miles2912:
I would go through the checklist here and see if it helps. Towards the bottom of the page is the troubleshooting. http://www.ultimarc.com/ipac2.html |
| ultrageek:
I wonder if the tristed pair wiring in the cat 5 is inducting a singal into the other pair(s). I'v seen stranger. I know that this is extremely low voltage and shouldn't be an issue, but since the Cat 5 is new to the design, it's a likely contributor to the problem |
| CrazyKongFan:
Isn't that why the twisted pairs in cat 5 are twisted in the first place, to prevent interference? |
| bkenobi:
You are not inducing a signal by a button press. I'm not an EE, but I know that inducing a current requires a high current on the source side. You have (essentially) 0 amps running through the buttons, so you will have 0 amps running down any other conductors. You may have 5 volts, but it's got (essentially) no current so you can't induce with it. |
| Navigation |
| Message Index |
| Next page |