Main > Main Forum
Wiring Tact Switches to Xbox 360 Triggers
(1/2) > >>
foreverlastd:
Hi there, I'm building a custom made Xbox 360 arcade stick and I'm hung up on wiring up the triggers. I've looked around and couldn't find the answer I needed. I just need to see how the tact switches need wired and where (if needed) the resistors are attached. I attached an image to the topic. If you could just draw the connections (and resistors).

Thanks
-Mike

HaRuMaN:
What controller are you using?  (MadCatz, Wireless, Wired Official, etc).
foreverlastd:

--- Quote from: HarumaN on August 17, 2009, 09:08:30 am ---What controller are you using?  (MadCatz, Wireless, Wired Official, etc).

--- End quote ---

It's the official wireless controller.
HaRuMaN:

--- Quote from: foreverlastd on August 17, 2009, 10:54:20 am ---
--- Quote from: HarumaN on August 17, 2009, 09:08:30 am ---What controller are you using?  (MadCatz, Wireless, Wired Official, etc).

--- End quote ---

It's the official wireless controller.

--- End quote ---

Is it the older, non-common ground PCB, or the newer common ground PCB?
foreverlastd:

--- Quote from: HarumaN on August 17, 2009, 11:23:33 am ---Is it the older, non-common ground PCB, or the newer common ground PCB?

--- End quote ---

I can't look at the physical controller at the moment (as it's 130miles away) but I know it's the same design as this one ( http://www.instructables.com/files/deriv/FLR/BM3T/FIN3ZDRY/FLRBM3TFIN3ZDRY.MEDIUM.jpg ) .
Navigation
Message Index
Next page

Go to full version